POLARIS RANGER/RZR INSTALL PHOTOS.


Polaris Ranger 002

Upper dash panel may have to be removed for easier mounting of block and L-SHAPED ROD.

A small hole is required (for L-SHAPED ROD) in the dash panel before reinstall.

Polaris Ranger 003

Don't let this pic intimidate you, Dase removal and installation is easier then it looks.

Polaris Ranger 004

Attach hand control tube to L-SHAPED ROD mount. A small slit may be required in under dash for brake rod.

Polaris Ranger 006

Attach pedal block to brake and gas rod and adjust length as required.

Polaris Ranger 007

Then tighten it all down! And test drive to be sure it all works correctly before turning it over to the disabled driver.


POLARIS RANGER RZRS


2010 POLARIS RZR S (5)

Install mounting block and L-ROD and lightly tighten.

2010 POLARIS RZR S (6)

Make sure L-ROD is not hindering steering.

2010 POLARIS RZR S (7)

Mount hand control to L-ROD and tighten block.

Continue install as instructed above on Polaris Ranger.


POLARIS RANGER RZR


IMG_0387

Attach Steering Knob in location needed and tighten.

IMG_0388

Some drilling may be required for brake block mounting.

IMG_0389

Adjust hand control, gas and brake rods and tighten before test driving!


www.auto-handcontrols.com